To install fence, you need to prepare the area, install fence fence post and install the fence panels. It is easy to install.
First you need to prepare the area. Start by marking out the fence line where you want to install the panel. Use string or a chalk line to ensure your line is straight. Check your local ordinances to make sure you are installing the fence at the correct distance from property lines.
Measure and mark the post locations: The distance between each post will depend on the width of your fence panel. Typically, you will place a post at each end of the fence panel and one or two more evenly spaced in between. Use measuring tape and marking paint to mark the locations for each post along the fence line.Dig post holes: Using a post hole digger, dig the holes for your fence posts.
The depth and diameter of the holes will depend on the type of fence and the height of the panels. As a general rule, the holes should be about one-third the height of the fence panel and at least 8 inches in diameter. Make sure the holes are evenly spaced and aligned with your marked post locations.
Set the posts: Place a post in each hole and use a level to ensure they are plumb (i.e., straight). Fill the hole around each post with quick-setting concrete mix, following the manufacturer’s instructions. Double-check the alignment and height of the posts before the concrete sets.Attach the fence panel: Once the concrete has set and the posts are secure, it’s time to attach the fence panel. Position the panel between the posts, making sure it lines up evenly with the top and bottom of the posts. Use screws or nails to secure the panel to the posts. Repeat this step for each fence panel.Secure the panels: Additional support may be required to help stabilize the fence panels.
Finally, check that all the panels are secure and level. Trim any excess portions of the fence panels if needed.
If you need the video of installation, please construct us.
Post time: Jul-25-2023